Half Slim SATA E231 is a SATA III 6Gb/s MLC eMMC flash module. With a standard 22-pin (7+15) SATA interface, it allows system designers to leverage standard SATA cabling or host connections for embedded applications with faster booting and smaller footprint.
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
Conformal Coating
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
Conformal Coating
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
OCP/OVP
Equipped with a built-in OCP (Over Current Protection) and OVP (Over Voltage Protection) IC, the SSD is able to shut down power to protect its data when encountering abnormal currents and voltages.
Device Sleep Mode (DEVSLP)
This power save mode targets only 5mW or less, allowing the product to go into sleep mode when inactive; reducing power consumption and heat generation when it is not in use.
Write Protect
Optimized by software or hardware, the write protection can be set up for read-only permission to avoid data overwriting.
Quick Erase
The quick erase command instructs SSD controller to write 1 to all of the blocks for data security. Even if the device is powered off after a quick erase command has been issued, the process will continue after power has been restored.
StrongMLC
MEMXPRO develops StrongMLC technology to highly enhance a 6x increase in MLC endurance with reduced capacity, offering SLC-equivalent performance at a relatively much lower cost than regular SLC.
TRIM
The TRIM command allows the OS to tell SSD which blocks of data are no longer in use and can be erased. This enhances write performance by releasing space.
Wear Leveling
Wear Leveling algorithms and bad block detection schemes are used to extend life span and efficient utilization of the NAND flash memory.
mSMART
mSMART is a MEMXPRO's utility which is designed to provide product details and S.M.A.R.T. information. Our customers are able to monitor health, temperature and the lifespan of each installed disk in the system.
Thermal Sensor
The sensor in a controller can measure temperature through a product to enhance its data integrity. With SMARTPro, customers can monitor the temperature of MEMXPRO's SSD inside their system.
ESD and EMI Protection
MEMXPRO’s products are designed to comply with Electrostatic Discharge (ESD) and Electromagnetic Interface( EMI) standards.
