mSATA EB31 series is a SATA III StrongMLC flash module with extend endurance. mSATA products can be configured as boot drives or data storage devices, providing excellent performance and efficiency with faster read/write speeds.
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
Conformal Coating
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
Conformal Coating
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
30µ" Gold Finger Thickness
Gold fingers are gold-plated card-edge connectors resistant to wear agaist repeated insertion. MEMXPRO designs our embedded storage module with 30µ" gold finger thickness for better signal quality.
OCP/OVP
Equipped with a built-in OCP (Over Current Protection) and OVP (Over Voltage Protection) IC, the SSD is able to shut down power to protect its data when encountering abnormal currents and voltages.
Device Sleep Mode (DEVSLP)
This power save mode targets only 5mW or less, allowing the product to go into sleep mode when inactive; reducing power consumption and heat generation when it is not in use.
StrongMLC
MEMXPRO develops StrongMLC technology to highly enhance a 6x increase in MLC endurance with reduced capacity, offering SLC-equivalent performance at a relatively much lower cost than regular SLC.
TRIM
The TRIM command allows the OS to tell SSD which blocks of data are no longer in use and can be erased. This enhances write performance by releasing space.
Wear Leveling
Wear Leveling algorithms and bad block detection schemes are used to extend life span and efficient utilization of the NAND flash memory.
mSMART
mSMART is a MEMXPRO's utility which is designed to provide product details and S.M.A.R.T. information. Our customers are able to monitor health, temperature and the lifespan of each installed disk in the system.
Thermal Sensor
The sensor in a controller can measure temperature through a product to enhance its data integrity. With SMARTPro, customers can monitor the temperature of MEMXPRO's SSD inside their system.
ESD and EMI Protection
MEMXPRO’s products are designed to comply with Electrostatic Discharge (ESD) and Electromagnetic Interface( EMI) standards.