MEMXPRO Half Slim ET30 is budget friendly SATA III 6Gb/s embedded flash storage with 10K P/E cycle 3D TLC NAND to boost system performance and enhances the endurance compared to 2D NAND SSDs. The ET30 series features LDPC ECC and RAID Engine technologies, ensuring data integrity and the safety of data transmission. With 3D TLC NAND’s projected continued improvements in scalability, it is a new era of density, performance and cost benefits for embedded and industrial applications.
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
Conformal Coating
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
Conformal Coating
According to customer’s requirement, MEMXPRO can apply a special protective coating on selected products against moisture, dusts, and chemical contaminants; preventing short circuits and corrosion.
30µ" Gold Finger Thickness
Gold fingers are gold-plated card-edge connectors resistant to wear agaist repeated insertion. MEMXPRO designs our embedded storage module with 30µ" gold finger thickness for better signal quality.
OCP/OVP
Equipped with a built-in OCP (Over Current Protection) and OVP (Over Voltage Protection) IC, the SSD is able to shut down power to protect its data when encountering abnormal currents and voltages.
TRIM
The TRIM command allows the OS to tell SSD which blocks of data are no longer in use and can be erased. This enhances write performance by releasing space.
Wear Leveling
Wear Leveling algorithms and bad block detection schemes are used to extend life span and efficient utilization of the NAND flash memory.
mSMART
mSMART is a MEMXPRO's utility which is designed to provide product details and S.M.A.R.T. information. Our customers are able to monitor health, temperature and the lifespan of each installed disk in the system.
Thermal Sensor
The sensor in a controller can measure temperature through a product to enhance its data integrity. With SMARTPro, customers can monitor the temperature of MEMXPRO's SSD inside their system.
ESD and EMI Protection
MEMXPRO’s products are designed to comply with Electrostatic Discharge (ESD) and Electromagnetic Interface( EMI) standards.
